PEMF Therapy

0.5 Hz

Low Delta Frequency. This frequency assists the re-entrainment of normal brain and neurological signals and regenerates cell activity. It is often used to reduce anxiety, metabolic over activity and insomnia. It also has an anti-inflammatory effect. It is always the recommended starting level.

4 Hz

A higher Delta frequency. Many users and practitioners have commented that this setting assists with the relaxation and a good night’s sleep’. It may also help ease some stressful and painful conditions (temporary relief).

8 Hz

The Schumann Frequency. This setting has a soothing effect on tired and sore muscles. It also promotes healing of damaged tissue and may assist in the relief of aches and pains. It is considered the best setting for everyday use to assist the body’s own detox mechanisms and maintain fitness and is an Alpha frequency that mimics the Earth’s own frequency.
This is the frequency which is the most beneficial as a setting during long-haul flights.

16 Hz

The Beta Frequency. Most users report a sense of balance and freshness at this setting, even after travel, late nights and exercise. This setting enhances blood flow and circulation making it a perfect pre-exercise boost. Many report it as the fastest setting for pain relief. It is recommended for short-term use (20 minutes), alternating with the 8Hz setting which is recommended for longer periods

1. This unit uses 2 x 1.5V alkaline batteries (AA). Add batteries by opening the battery compartment that can be found on the back case of the device. When exhausted, replace with two of the same type, paying particular attention to the correct polarity alignment as shown within the battery compartment.

2. The control panel has one multi-function button and 6 indicator LEDs. Refer to the diagram on page 7.

3. The ON/OFF/SELECT switch controls both the power to turn the device ON and OFF and also selects the desired frequency. A single press will activate the unit. One of the LEDs will light up for approximately 2 seconds (the default setting is 0.5Hz or the last setting that was used) after which the positive (+) and negative (-) pulse indicators will begin to flash alternately.

4. To change the frequency, press the ON/OFF/SELECT button twice in quick succession. The next frequency will light up for 2 seconds before it is activated. To move between frequency, press the ON/OFF/SELECT button once before the 2 second activation starts.

5. The unit will operate at the selected frequency for 5 minutes ON and 5 minutes OFF automatically repeating that cycle until switched off. To turn the unit OFF press the ON/OFF/SELECT button once.

6. There are four frequency settings: 0.5Hz, 4Hz, 8Hz, 16Hz

7. While in pause mode only the currently selected LED will flash.

8. If the batteries are too low to operate the unit the LEDs will not flash. Replace with batteries of the same type.